Nucleo-L152RE with ST-Link board still attached and power from USB; STM32CubeIDE configured as picture. Freq at 1000K to match slow speed set in the Monitor.

I can hit the 'Blink the LED' and that works. Back to the IDE, when I hit the debug button I get these results: STMicroelectronics ST-LINK GDB server. Version ...

May 11, 2023 · I attempted to close STM32CubeIDE before launching Dashboard to ensure that the connection is not being used by any other application.

Apr 9, 2019 · If the software is crashed on the target, the tool have no answer; the serial path is not correct : Nucleo should be connected by the ST-Link ...

I'm having an issue using STM32CubeIDE to program my blue pill boards. I get the below error each time. Error in final launch sequence: Error in.

Mar 8, 2024 · After applying some settings, I checked that my board got a problem. I couldn't connect to my board anymore(Cubeide- Debugging Mode or Cube ...

Jan 25, 2024 · I have put the project on github. The simple project needs to flash a few LEDs and goes into "No STM32 targets found" easily, after a few times ...