For finger to work, you need to allow "transport input telnet" if you don't allow this then you can have ip finger enabled on the router, but you'll get ...
Missing: q= | Show results with:q=
People also ask
What is the finger service on a Cisco router?
How to check IP address in Cisco?
How to show CDP neighbors IP address?
What is the show IP command in Cisco?
Duration: 12:49
Posted: May 25, 2016
Posted: May 25, 2016
Missing: q= | Show results with:q=
The service finger command has been replaced by the ip finger command. However, the service finger and no service finger commands continue to function to ...
Missing: q= | Show results with:q=
service finger. The service finger command has been replaced by the ip finger command. However, the service finger and no service finger commands continue to ...
Oct 4, 2022 · Introduction. This document describes the use of the ping and traceroute commands on Cisco routers. Prerequisites. Requirements.
Missing: finger | Show results with:finger
finger. IP System Management Commands. 7. IP System ... Q. Fragment reassembly time exceeded. R. Source ... IP System Management Commands. 12. IP System Management ...
How to enable and disable the Finger service or protocol in Cisco switches
community.cisco.com › ta-p
Jun 22, 2009 · To configure a system to accept Finger protocol requests (defined in RFC 742), issue the ip finger command in global configuration mode.
Missing: q= | Show results with:q=
Mar 15, 2022 · This document describes how to configure. verify and troubleshoot 802.1Q tunnels (QinQ) and Layer 2 Protocol Tunneling (L2PT) on the Catalyst ...
Jan 11, 2018 · (Optional) Displays the entries under the Virtual Private Network (VPN) routing and forwarding (VRF) instance specified by the vrf-name argument ...
Missing: finger | Show results with:finger
This feature provides Layer 2 Tunneling support for QinQ and Layer 2 Protocol Tunneling (L2PT) on Integrated Services Router Generation 2 (ISR G2).