The service finger command has been replaced by the ip finger command. However, the service finger and no service finger commands continue to function to ...
Missing: q= https% 3A% 2F% 2Ft5% 2Frouting% 2Fservice- 2Ftd- 2F1321352
People also ask
What is the cisco default IP address?
What is the command to bring up the interface on a router?
How to enable IP route in cisco switch?
What is the cisco IP route 0.0 0.0 command?
i've always done. service finger. now i see that what service finger does is changes. no ip finger. to. ip finger. so now i'll just use. ip finger.
Missing: q= 3A% 2Ft5% 2Frouting% 2Fservice- 2Ftd- p% 2F1321352
I am looking for some clarification as I keep second guessing myself. Do these two commands do the same thing? the IP Address for the interface
Missing: q= https% 3A% 2F% 2Ft5% 2Frouting% 2Fservice- finger- finger% 2Ftd- 2F1321352
Hi Gurus, I have turned off the command, no service finger but somehow it is not displaying at the running config.How can i do it?
Missing: q= https% 3A% 2F% 2Ft5% 2Frouting% 2Fservice- 2Ftd- 2F1321352
Hi. the U result is from an ICMP packet host unreachable, could be a result of route summarization if you are using EIGRP. Try a show IP route and see if ...
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included ...
There are two commands to disable finger service on a router. Newer command - no ip finger. Older command - no service finger. Cisco routers support both ...
Missing: q= https% 3A% 2F% 2Ft5% 2Frouting% 2Fservice- 2Ftd- 2F1321352
Oct 4, 2022 · Introduction. This document describes the use of the ping and traceroute commands on Cisco routers. Prerequisites. Requirements.
Missing: 3A% 2Ft5% 2Frouting% 2Fservice- finger- finger% 2Ftd- 2F1321352
In order to show you the most relevant results, we have omitted some entries very similar to the 8 already displayed.
If you like, you can repeat the search with the omitted results included. |